 Wheels
and discs should be stored
in dry premises, at room temperature,
providing to arrange large diameter
units in a standing position on wooden
shelves, while smaller units should
be placed in an horizontal position.
All products are
subjected to severe tests before leaving
our factory. Nevertheless, a preliminary
audio and visual check-up should be
carried out before mounting in order
to verify the integrity of the wheel.
Do not use damaged and expired
units and those which have
been subjected to impacts or unusual
stresses. When using wheels and discs,
it is always recommended to allow
the machine to idle for a few minutes
before use.
Always use the recommended
personal protective equipment
according to the accident prevention
rules, depending on the work being
carried out.
The optimal clearance angle
of the grinding disc should never
be inferior to 35°. Never
use cutting discs for grinding works.
Do not use badly maintained
and unsafe machines, or machines
with too much slack on the shaft and
flanges.
Keep to the characteristics
described on each wheel or disc by
checking out the specific suitability
for the material one is working on.
Check expiry date and verify that
the no. of revolutions of the machine
do not exceed the maximum no. of revolutions
reported on the abrasive wheel.
|
